If they are very hot while driving, adjust the bearings ( see subsection 4.1.4.4).Ĭar break-in is an operational process that allows you to prepare units and key components for intensive use, as well as to identify at the initial stage possible malfunctions and defects.ĭespite the fact that motors from leading car manufacturers are tested on special stands, it makes sense to run the car in and let the mechanisms function under load. Monitor the temperature of the front wheel hubs. It should be remembered that during the running-in period, the most intense stretching occurs.ĩ. On the ZMZ-4062 engine, check the tension of the accessory drive belt. On engines ZMZ-402 and ZMZ-4201, check the tension of the fan belts and (if available) the pump drive of the hydraulic power steering. At the first signs of overheating or hypothermia, eliminate their causes.Ĩ. Carefully monitor the temperature of the engine. Try to avoid driving in difficult road conditions (by deep snow, sand, dirt, etc.).ħ. To do this, you need to timely engage the gear corresponding to the speed of movement.ĥ. Try to avoid driving at high speeds and with the maximum engine speed. Start driving only after the engine starts to work stably with a fully open air damper of the carburetor (only for cars with engines ZMZ-402 and ZMZ-4201, on cars with a ZMZ-4062 engine, you can start moving almost immediately after starting the engine, after a little warm up).Ĥ. Before driving, warm up the engine at a low crankshaft speed.ģ. During the running-in period, the recommendations below must be followed.Ģ.
Run-in must take place new car a mobile, as well as a car on which the engine was replaced or overhauled. How the car is operated during this period will largely depend on its reliability, durability and efficiency. The vehicle speed during the running-in period should not exceed: in the first gear - 25 km / h, in the second - 40, in the third - 60, in the fourth - 90 and in the fifth - 115 km / h.ĭuring the break-in period of the car (the first 2500 km of operation), intensive running-in of its parts takes place. Running in a new car: how many km and how to properly run in a new car How many engine break-in of a new Nissan Tiida car
Running in a new car: how many km and how to properly run in a new car.
0 kommentar(er)
